Hanger Pins

Enlarge Photo
Disclaimer: Image color may vary per monitor settings

Package Qty.

Add to Cart Add to Cart & Checkout

Description

Difficulty Level - Very Easy Hanger Pins are used to mount a variety of our soundproofing and sound absorption products.

Hanger Pins are packaged in quantities that treat a 24 in. x 48 in., 48 in. x 48 in. or 48 in. x 96 in. products.

Features

Soundproofing and sound absorption products can be permanently or temporarily mounted.
Hanger pins are useful to hold products in place while adhesives cure.
Made of galvanized steel.
Improves overall appearance of finished installation.
Installs with adhesive or with screws. When using screws be sure to hit studs or other types of supports.

Details

Great for these Products

Acoustic Foam Panels (1 inch thick only)
Class A™ Acoustic Foam Panels (1 inch thick only)
Echo Absorber™
Quiet Barrier® Soundproofing Composites
Quiet Barrier® Specialty Composites

Package Contents to install 24 in. x 48 in. products includes the following quantities:

6 - 1.25 in. Pins
6 — 1.5 in. Captive Washers
6 — .75 in. Protective Caps

Package to install 48 in. x 48 in. products includes the following quantities:

9 - 1.25 in. Pins
9 - 1.5 in. Captive Washers
9 - .75 in. Protective Caps

Package to install 48 in. x 96 in. products includes the following quantities:

15 - 1.25 in. Pins
15 - 1.5 in. Captive Washers
15 -.75 in. Protective Caps

Cautions and limitations

Extremely sharp, wear gloves.

Installation Details

Tools Needed: Caulk Gun (if using adhesive), Drill or Screw Gun (if using screws), Level,Tape Measure, Pencil, Chalk Line (for large installs)

Materials Needed: PL Construction Adhesive or 1.5 in. screws

This product is simple to use and install. Attach the hanger pin to the mounting surface then push the product on to the pin so the tip of the pin punctures through the product. Place the Captive Washer over the shaft of the pin and push the washer against the soundproofing or sound absorption product. Then push the Protective Cap on to the pin to complete the installation. Hanger Pins can be installed to walls or ceilings with Pl construction adhesive or with screws. Hanger pin must be located at studs or other types of supports when using screws as the primary fastener. Hanger Pins will work with any product up to a 2 inch thickness. Hanger Pins can be installed on wood, steel or fiberglass mounting surfaces.